Off Roading Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
1,929 Posts
Hey Rick,
If those are the original 2-piece axles I wouldn't pull them unless you are ready to drop $300 for some 1-piece axles. I spun a hub on my 2-piece axles running 32" tires. When I replaced them I used Moser's 1-piece axle kit. I also did gears and a locker at the same time. The moser kit includes bearings and you can install all new seals while you are at it. If you are just doing some preventative maintenance, I would just wait until one of the hubs spins and then redo everything like I did. Once you remove the hub from the shaft to pull the axles you increase your risk of spinning a hub significantly. Check out my website there is a write-up on the model 20 gear swap. Also, did you see my update on the engine post?

Later,
Tom

http://home.off-road.com/~tom85cj7/home.htm
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top