Off Roading Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
does anyone know what the baseline mesurment for pinion depth is for this rear end. The gears I got have the depth makings on them but not a + or - # referenced to the factory base line. I would also like these same #'s for a dana 30 all this is in a 1985 jeep cj7 What is the factory base line for each.
 

·
Registered
Joined
·
11,504 Posts
I've copied the pertinent pages from the factory service manual, but they're too big to post. I'd e-mail them to you if you had an address in your profile.
 
1 - 4 of 4 Posts
Top