Off Roading Forums banner
1 - 2 of 2 Posts
G

·
Discussion Starter · #1 ·
Just put 30's on today! The only time I rub is when I fully turn to the left. Rubs slightly on the lower sussension arm. Doesnt rub on the other side. I was wondering if the adjusting bolt that meets the contact points of the steering nuckle can be turned out slightly? Mine looks like its got a spot weld on it. If so this would allow me to turn and not have to worry about rubbing. Wouldnt loose much turn, cause like I said its only a slight rub. Just hate to forget and keep tearing up new tires. Thanks Dennis

88 comanche 63 wagoneer
 

·
Registered
Joined
·
1,663 Posts
yup thats what that bolt is there for. Just turn it until you don;t rub anymore. But be aware that you will lose a lot of turning radius, and that is never good.

Have fun.

Todd



88' XJ
3" rusty's
1.75" Shackles
2" RE spacers.
Rusty LCA's.
RE adj trackbar
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top