Off Roading Forums banner
Cancel

4-low popping out of gear

548 Views 6 Replies 5 Participants Last post by  Koko, 
G
hey all...i'm having some trouble with 4-low popping out when under torque...the passenger side t-case bolt was just replaced due to it being stripped...can the bolt being too tight cause this? There were no problems before the new bolt, but the whole case was loose...I don't have a body lift or anything, so this is the only thing I can think of....thanx guys!!!!
See less See more
Reply
Save
Like
1 - 1 of 7 Posts
S
There is a sliding collar on the main shaft between the gears that causes this , mine is worn and has a hard time staying in . It was doing it in low , I just turned the collar around so it would pop out of high instead . Wish I had one of those parts list , I'd like to see if a new one is available .
Sarge
Reply
Save
Like
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Off Roading Forums
A forum community dedicated to all off road vehicle owners and enthusiasts. Come join the discussion about performance, engine swaps, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
GM Standard IFS Trucks & SUV's Ford 67-96 F-Series, 78-96 Bronco General 4X4 and Off-Road New Member Introductions Tire Tips, What Works Best
Top