Off Roading Forums banner
Cancel

4.0 in a CJ - CPS bellhousing mount

885 Views 1 Reply 1 Participant Last post by  **DONOTDELETE**, 
S
I have decided to put a 4.0 into the Scrambler. Has anyone had any experience mounting the CPS (crankshaft position sensor) in the 258 bellhousing?

It may be easier to get Mopar dampener from the MPI kit. Has anyone made their own mount for the CPS using the Mopar dampener?

Any input would be appreciated.

Reply
Save
Like
1 - 2 of 2 Posts
G
I have a 4.0 in my 80 CJ 7. I used the AA bellhousing. The Mopar kit was not out when I made the swap. I believe the dampner from Mopar kit is cheaper. I had all the parts for a factory installation ( wiring harness, flywheel ect...) so it was easier for me. You will enjoy the swap[. Good luck.

Reply
Save
Like
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Off Roading Forums
A forum community dedicated to all off road vehicle owners and enthusiasts. Come join the discussion about performance, engine swaps, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Jeep-Short Wheelbase GM Standard IFS Trucks & SUV's Ford 67-96 F-Series, 78-96 Bronco General 4X4 and Off-Road Tire Tips, What Works Best
Top