1.3 valve adjustment
1985, G13A, 1.3ltr with 5spd box.
I have seen a message ebfore stating the cold specs for adjusting the inlet and outlet tappets on the 1.3 engine. Can someone give me these again. I think it was .12 inlet and .10 outlet. I could be very wrong.
Also what is the "supposed" readline of the 1.3?
I have seen it done before to a hot engine using .28 and .25 (I think, I used the manufacturers measurments under the hood) but it's hard to keep the engine hot and it hurts if I touch someting *laugh*. To my knowledge the bottom pulley TDC(top dead center) marker should be in line with "0".
Any help would be greatly appreciated.
1.6 22R off it's rocker
"If it's too hard or you're a pussy, give me a go at it"