Clutch Removal - Off-Road Forums & Discussion Groups
Snowmobile Lounge All general discussions relating to Snowmobiles

LinkBack Thread Tools Display Modes
post #1 of (permalink) Old 12-12-1999, 08:01 AM
Posts: n/a
Clutch Removal

I am trying to remove a Comet 108C clutch from my 89 Mach 1. I am using a brand new puller and have made it as tight as i can with a 1/2" rachet. I have also tried tapping it with a hammer. I have also sprayed around the crank shaft with WD-40. Any suggestions would be appreciated.

Thanks in advance,

Sponsored Links
post #2 of (permalink) Old 12-12-1999, 10:22 AM
Posts: n/a
Re: Clutch Removal

Sometimes it requires more than a tap, but the best way is an impact gun.


post #3 of (permalink) Old 12-13-1999, 05:06 PM
Posts: n/a
Re: Clutch Removal

hey there is a way that is a little easier on your pullerpack the cavity that the puller is going into full of grease then impact it off this will be easier on your puller especially if its an offshore unit good luck

Sponsored Links

Quick Reply

Register Now

In order to be able to post messages on the Off-Road Forums & Discussion Groups forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode

Posting Rules  
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

For the best viewing experience please update your browser to Google Chrome