If your talking about intake then NO. The angle of the 2 bolt holes on either side of the carb plate are slightly different. I've taken a die grinder and oblonged those holes before but wouldn't recommend it.
THe intake base from 85-86 F-body TPI's would fit they change the middle bolt holes in 87.Either way you can just elongate the middle bolt holes to fit..If you buy an aftermarket TPI intake base like from Edelbrock you dont need to modify the holes..Works for both
I will assume that you are talking about the bell housing bolt pattern (just a guess). If so, yes it is the same.
BTW... Go RED WINGS
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Off Roading Forums
1.4M posts
22.4K members
Since 1999
A forum community dedicated to all off road vehicle owners and enthusiasts. Come join the discussion about performance, engine swaps, modifications, classifieds, troubleshooting, maintenance, and more!