Off Roading Forums banner

WOOT!-Got my axles and my money!

430 views 6 replies 4 participants last post by  **DONOTDELETE** 
G
#1 ·
Hey-I finally got my accident money from January 12! Went to heaven...uh..junkyard today and spent all morning looking and measuring for axles. Then I saw them come in with a van(doubletake)...it was a 4x4 Ford Quadravan! 460/C6auto/sometransfercase/D44front w/doulbe piston calipers/rear D60 w/small fin 12" semi-floater...SWEET. Asked the owner how long its been off the road..he said just last month it failed inspection due to body rot! Got the motor/tranny+transfercase for $200.00! And BOTH the axles for $125...its good to know people!....sorry just had to tell someone!..bought a new welder and now its time to shorten them axles...I live in Massachusetts full width axles wont pass inspection...or the local P.D.

MARK (OIIIIO) LANGMOTORSPORTS
1977/CJ7/GLASSTUB/460CIFORD/C6AUTO/4"LIFT/33'S
 
#2 ·
Nice score!! Dropping the engine and tranny into your Jeep? If so, DAMN! Hehehe... Good luck!

"James and the Giant Jeep"
1993 Wrangler 4.0/5spd, Herculined Interior, D44s Soon
 
G
#5 ·
I already have the big-block and C6 in there and the transfercase...just tired of blowin' the rear 20 (4 times). Just was waiting for the money and the right donor vehicle!

MARK (OIIIIO) LANGMOTORSPORTS
1977/CJ7/GLASSTUB/460CIFORD/C6AUTO/4"LIFT/33'S
 
G
#7 ·
Hey-Ive already fired the thing up when I took it out of the box and installed the wall plug. I built a roll-around cart for it and welded up some 3/8" rod on both sides of my lawn tractors plow, and a 3/16" piece of angle iron on the bottom lip. I had some left-over fluxcore and it worked fine the pattern was great and the controls are easy to use.

MARK (OIIIIO) LANGMOTORSPORTS
1977/CJ7/GLASSTUB/460CIFORD/C6AUTO/4"LIFT/33'S
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top