#3.......I modified the rear gate to fold down and it didn't cost nothing. Just what welding wire & cutting disc I used. The enclosure you see is a rear door from a tin-top. I will be weathering this in and modifying it some more. My next step is the rear platform.
#3.......I modified the rear gate to fold down and it didn't cost nothing. Just what welding wire & cutting disc I used. The enclosure you see is a rear door from a tin-top. I will be weathering this in and modifying it some more. My next step is the rear platform.
Thanks buddy fer fixin the pics for me. As for the hinges.......I used the 2 that were on the end of the tailgate. One side was longer than the other so all I did was cut one end down to match the other. At that point I layed the tailgate in the open position [note] it is good to have 2 extra people here to hold the gate for measurments. Then I layed the hinges where I wanted them to go and marked for cutting. The way I have done my set-up.....I had to cut away the inside/bottom on the gate and also cut the area below the gate as if it were closed. This was boxed in afterwards to give it a kind of clean look. After all of the cutting/notching was done I welded everything into place and the rest is history my friend. I hope this helps ya out. There are a few more things I am wanting to do, but they might get put on hold because hunting season is right around the corner.
David
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Off Roading Forums
1.4M posts
22.4K members
Since 1999
A forum community dedicated to all off road vehicle owners and enthusiasts. Come join the discussion about performance, engine swaps, modifications, classifieds, troubleshooting, maintenance, and more!