 |
Off-Road Forums & Discussion Groups
(https://forums.off-road.com/forum.php)
- Jeep-Short Wheelbase
(https://forums.off-road.com/jeep-short-wheelbase/)
- - measuring a drve shaft
(https://forums.off-road.com/jeep-short-wheelbase/88168-measuring-drve-shaft.html)
measuring a drve shaft
yester day during one of my temper tantrums (4 wheel parts wholesalers and '89 ford taurus heater core) i was on my way home and i twisted my drive shaft, before i take it out i want to measure it. do go center of horiz u-joint caps?
gdm |
Re: measuring a drve shaft
Measure from face to face of the yoke where the u-bolt/strap holds the joint cap on transfer and rear end yoke.
GP'n |
Re: measuring a drve shaft
And you should measure both the top face to face and bottom face to face, then average the measurements. This was the procedure given to me by Tom Woods when I ordered new shafts from him.
Max 82 CJ, some stuff stock, some stuff not Have you hugged your Jeep today? http://www.alpine14rs.org |
| All times are GMT -5. The time now is 08:26 PM. |
Powered by vBulletin® Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
User Alert System provided by
Advanced User Tagging (Pro) -
vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.
vBulletin Security provided by
vBSecurity v2.2.2 (Pro) -
vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.
Copyright ©1994-2009, VerticalScope Inc. // Off Road forums & discussion groups sitemap
side by side | atv | dirtbike | snowmobile | sandsport | competition | land use | Jeep | Toyota | Ford | GM