does someone know or has a picture from a dashbord were a steel grab bar is mounted? Because I have a new Grab Bar and I do not know were this was originaly mounted on a 74 CJ5 (dashbord is new and has no holes)
Over here in Germany (guess what) nobody now`s!
Thanks for Your help.
On my '81 CJ 7, the stock grab bar ("sissy bar" "Oh [censored]!" bar etc. etc.) is mounted so that the mounting holes are centered 3 1/2 inches below the top of the dash (the metal below the cowl rubber) and 2" and 19" respectively from the right edge of the dash.
If I were you, I would check to make sure the distance, center-to-center) of the mounting holes on your grab bar is 17" before grabbing the drill.
And I'll use the inch measurements rather than metric because they came out dead on by my tape measure. I assume you have an inch measuring device handy.