Join Date: Jun 2000
Location: Tualatin, Oregon, United States of America, North America, Earth, Milkyway Galaxy, Universe...
Thanked 0 Times in 0 Posts
Re: a few questions
First off, what engine/tranny/tcase combo are you planning on running? I think 4" lift springs are a bit much for running 38.5's. 2.5" springs should be more than enough. I'd rather cut some sheet metal then jack it sky high, so the COG doesn't raise up too much. Depending on your drivetrain setup, you may or may not have some driveshaft angle problems. I'm running about a 1.5" lift springs on my YJ, and have it setup SOA. I had some nasty driveline problems with my stock setup, so I swapped in a D300 and that took care of it. My front driveline is just about at the point of needing a CV driveshaft, but I don't run high speeds, so it doesn't come into play much.