CJ v-8 motor mounts - Off-Road Forums & Discussion Groups
Jeep-Short Wheelbase All discussion of short wheelbase Jeeps: CJ, TJ, YJ and JK

LinkBack Thread Tools Display Modes
post #1 of (permalink) Old 02-20-2003, 01:37 PM
Posts: n/a
CJ v-8 motor mounts

Finally I am ready to put a v-8 in place of my 4 cyl. My question is this, I had mounts out of a 79 CJ w/304. Can I use these mounts in an 86 CJ with 360? I have an AMC360 from a Wagoneer, a T-18 and a Dana 20 with the tera low kit. I was told I can use my current clutch cylinder and slave cylinder to work with the T-18. Is there anything else I need to consider? Any problems to watch for?
Sponsored Links
post #2 of (permalink) Old 02-20-2003, 02:20 PM
Posts: n/a
Re: CJ v-8 motor mounts

Driveshaft length will be a consideration. You may need to shorten or lengthen them. Have fun on the swap,

TheBigUgly [img]images/graemlins/burnout.gif[/img]
Sponsored Links

Quick Reply

Register Now

In order to be able to post messages on the Off-Road Forums & Discussion Groups forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode

Posting Rules  
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

For the best viewing experience please update your browser to Google Chrome