Re: CJ3B Spring conversion???
A much easier way to go is to use the Holbrook Springs. They were written up in Four Wheeler Mag and another one also.
They are custom springs that are stock width but are about 9" longer than stock with an offset axle centering pin to locate
the axle in the stock location. I drove the 3b with the prototype set in Moab, Utah and believe me, they work.
Rich Imholt who owns "Bad Bee" the yellow 3b they were prototyped on ramped over 1,000 on a 23 degree ramp
with these springs with a spring under. They soak the bumps up real nice too. Holbrook Specialties can be reached
at 503-655-4747. They now have a web-site but don't know what the address is. Good luck. [img]images/graemlins/laugh.gif[/img] Nickmil