Off Roading Forums banner

flat top question

682 views 2 replies 2 participants last post by  bostonyj7 
#1 ·
Can I use the open knuckles flat tops from a 79 Chevy corp 10 bolt knuckle for my ford hub conversion on my Scout 44
 
#2 ·
Are you sure the knuckles that are flat tops are from a '79? If so, the knuckles should be fine, but the spindles will need to be the narrower inner bearing diameter spindles (if you are planning on using the ford f150/bronco 5 on 5.5 hubs) usually only found on the true chevy 44's or 73-77.5 wagoneers and probably a group of dodge 44's.

I actually have a set of the flat top knuckles and the spindles that are needed for the Ford hubs for sale if you are interested. Send me a private message if you are interested.

 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top