I hope you can help me

All the 86 Cj7 Have Dana 44 in the Rear?

The Rear Springs of Early CJ7´s (AMC 20) are the same of 86 Cj7 (Dana 44)?

Thanks for your help!

As far as which axle options for an '86. The dana 44 was an option. Look at this page.
http://www.off-road.com/jeep/swb/articles/specgrid.htm
I don't know if the springs themselves are the same, but I seem to remember that they have the same width. Don't know about spring rate or # of springs in pack. Some of the older wiser one's might know [img]images/graemlins/wink.gif[/img]

The "do a search" replies may be useless, but if you did a search, you would probally find the answers to your questions.

For example, you asked "All the 86 Cj7 Have Dana 44 in the Rear?"

my search yielded a positive answer in this post:

http://bbs.off-road.com/ubbthreads/s...;Number=778792

[img]images/graemlins/grin.gif[/img]

Its Hard to Find a 86 with Factory rear D44?

Are This Jeeps Rare?

Thanks Again!!

I have a Dana 44 in my CJ7 right now. I am building it into a rock crawler, so I'm going to be putting in 2.5 ton axles, so my Dana 44 (locked) might be up for sale for the right price. These are good axles, so I kinda wanted to keep it, but I will sell it for the right price if you are looking for one.

Thanks Truck boy, But i dont live in the U.S

By the Way, Which Tire size are you planing to Run?

Actually searching will typicaly get me the basics of almost all of my questions, if not completely answer it...

That aside, where do you live??? It's not in your profile...

As for your question, I can't answer it directly, but I can refer you to here Dana 44

I am going to run tractor tires (not sure on size yet) for when I go mudding, but for regular trailriding I am going to run either 42 or 44" boggers probably. Yeah, this thing is going to be a beast, but hey, why not spoil myself, eh? [img]images/graemlins/laugh.gif[/img] Also to run that kind of tire size and axles, I am going to have full front and rear hydraulic steering. I know some monster truck racers that's going to help me build the rear steering, since it will have to be done with a switch and it must be auto-centering. So yeah, I guess I am going a little over the edge.

Get the casting numbers off the axle and post it on the board someone here can find out the axle and the original gear ratio. Should be on the back side on the right I think... I may be wrong but I've done this in the pas... [img]images/graemlins/wink.gif[/img]

Its Hard to Find a 86 with Factory rear D44?

And What about the Rear Springs of Early CJ7´s (AMC 20) are the same of 86 Cj7 (Dana 44)?

Thanks!