I Might Just Know What I'm Talking About
Join Date: Aug 2001
Location: San Antonio, TX
Thanked 2 Times in 2 Posts
Re: corp 14 axle swap ? yes i searched
I'll try to help as best I can...
On a 10 bolt equiped BLAZER (your truck may or may not use the same, I don't know for sure) the driveshaft uses a 1310, where as a 14 bolt uses a 1350 series U joint. If you want to give it a try, go to the parts store and ask for a U joint that is a 1310 on one side and a 1350 on the other and see if it works.
You might gain some lift from the 14 bolt, but it would likely be so small that I doubt you would notice it... then again, there may be none at all. However, the 14 bolt will have less clearance underneath than you old 10 bolt did. From the diff to the ground I mean.