A little electrical confusion
Ok here's the deal, My wiring harness and truck is a 1990 GMC Jimmy. I want to keep this wiring harness in usable shape however, I have just dropped an early model 350 without any emissions junk, electric choke, nothing. I changed the oil pressure gauge and temp. It has HEI coil in cap distributor and I was wondering if anyone has done a swap like this. The other distributer is electronic because it was a TBI motor. So what do I need to hook up on this other one. There are the three going into the module at the base of the distributor housing and If I remember correctly there are a couple that go into the top of the cap&coil. Any insight into this would be greatly appeciated. Shes almost ready to take for a rip. I haven't gone out for a good chew in two months, just jonesing. Seen some nice, goopy mud on the side of the road the other day and went into convulsions.