Join Date: Feb 2003
Thanked 0 Times in 0 Posts
How to get off front output shaft yoke on NP241C?
I asked a while ago how to get off the front driveshaft on my 91 k1500. I needed to get that off because I wanted to change my front output shaft seal on my T-case. I have all the tools to get that nut off that holds the yoke on but my problem is the nut. I can't get it to budge one bit. It's not reverse threaded is it? I tried everything possible short of air tools and 2 hands doing it and nothing. I've even let it sit with WD-40 and nothing overnight.
Just wondering how the HELL you get that dumb nut off? I can't fit a torque wrench in there to tighten it correctly but I can get close to the right torque possibly using an extension. I just need to know how to get that stupid 28mm nut off that holds the yoke to the front of the T-case.