|Tools and Fabrication Forum for discussing the latest tools or fabrication methods for the Off-Road vehicle owner.|
| ||LinkBack||Thread Tools||Display Modes|
what should my next step be?
hey off road forum,
recently purchased my 05 sierra 1500 and was looking to do some more work to it. what would you recommend me doing next?
ENGINE is 5.3L V8 with 127,000 miles
-Volant Cool Air Intake
-Airaid Throttle Body Spacer
-Magnaflow Exhaust by Orange Muffler
-OPTMA YELLOW TOP BATTERY
-Has Custom Reworked 2500 3/4 Ton Leaf Springs for Towing capabilities. But DEAVER SPRING re-Worked the Leaf Springs, so they are extremely Soft when the truck is Unloaded but when it is loaded up with Weight the Lower Reversed Over-Load
- CAMBURG 5.5 Front end with Upper A-ARM and Red Coil and Bilstein Shocks.
-The Ball Joints and Tie Rods have all Been replaced within the last 15,000 miles with Heavy Duty ones.
-BILSTEIN SHOCKS 5150 on all 4 corners.
-HAnnamenn FIBERGLASS on the Front
-The Rear Bed Sides have been pulled out
BFGoodrich 35 INCH MUDD TERRAIN
BLACKROCK 17" RIMS
Front Tube Bumper and Skid Plate
-Sony Head Unit with Blue Tooth and I Pod and Aux connector
-Two 1500 and 2000 WATT AMPS
-Power Compositor to store power from Battery to power System
-Two 12" MA Subwoofers
-Kenwood Speakers all around
All times are GMT -5. The time now is 05:12 AM.