For Sale/want post

if any one has a motor for a rear window on a 79 bronco i need it mine dosnt work its the one that lowers and rasies the back windown. its the one that works eather with a key outside or fliping the switch on the dash if you have one let me know my email is mvlv1412@yahoo.com thanks alot i am located in jesery

[BigNorm]

What's the problem with the motor?

the motor its self is burned out ive tryed eveything i am getting power to the wires but its the motor thats dead need to find one and really dont want to send 175 for a new one if you have one let me know thanks also looking for a fuse box mine is rusted and crouted beond returned if you have one let me know

I have axles everywhere. These are all complete and in good shape. These all have 3.5 gears unless specified and are open axles except one. They are full width which is about 67" and drivers side drop.

Dana 44HP front coils 5x5.5 lug $300
Ford 9" rear big bearing 31 spline $150
Ford 9" rear same as above disassembled $100
Dana 60HP front leafs 8x6.5 lug $1300
Dana 44 rear housing & big 30 spline shafts 65" $50

If you want a leaf spring 44HP housing add $50 and tell me what width you want the mounts and I'll send it ready to bolt in.

I also have a most of the parts for a Dana 44 5 lug if you just need parts. I also have 3 78/79 Ford trucks that I am parting out if you need parts.

PM me if interested in parts. Thanks!

[foxracing706]

I have a Third member out of a 74 pickup with the 9 inch. Has about 2.73 gears in it. complete. Also have two 28 splined axles that are 31 inches long for sale in Phoenix Az.

Brad

[Cosmo]

Set of 4 Mud Kings......2 of the tires are good shape, about 50-60% tread, the other two are pretty well worn (I have been running them driving back and forth to work though) but would hold a guy over for a short time before having to buy a new pair. Rims are white modular 7" wide with 3.5 or 3.75" backspacing. 5 on 5.5 pattern.

Bonus 5th tire wheel......wheel matches the other 4, but tire is a 215/75/15, old but never seen pavement.

Pick up in the Kansas City area or may meet you if it isn't too far...... $150

PM me if interested. Will send pics.

[studlybil03]

Got some stuff for sale:

Ford F150 D44: Axle has spring perches welded on, however radius mounts are still there and usable. 1978 Ford 9" rear end. Both axles have about 8000 miles and front axle was never engaged in 4wd.

5.13 gears
Trac Loc Locker
WARN Hubs
Balljoints/bearings all replaced
Asking 600 obo

1978 Ford 9": Axle is a big bearing housing.

5.13 gears
EZ locker
Disc Brake conversion
Differential bearings all rescently redone with addition of new locker (0 miles on new bearings)
Axleshaft bearings/seal also replaced with 0 miles
Asking 500 obo

**I will sell axle combo for 1000**

Chevy front 4" EZ ride leaf springs (47" in length) - 50 bucks
98 Durango rear leafs, 2.5" AAL installed - 50 bucks

I will post pictures tonight.

http://cgi.ebay.com/ebaymotors/ws/eB...?ViewItem&rd=1

Rust free Ford replacement TAILGATE off 1990. Needs regulator work. $350 In Rochester NY area. Will not ship.

Parting out 90 no motor trans trans case.

nospamSnafu12@aol.com REMOVE NO SPAM FROM ADDRESS

Selling my 1988 Eddie Bauer Bronco. 351, C-6 auto, manual locking hubs. Has 151,000 on it. I haven't had it on the road for a while but have always ran it. It always starts right up even in winter. Things I know to be good: Tailgate was replaced and there is no rust on it. Window works from inside switch only. Good NAPA radiater. Oil pump replaced. Timing chain replaced. Recent battery. Good 31" tires. Summit shorty headers. Valve cover gaskets recently replaced. Always used Mobil 1 synthetic and had synthetic in both rears. Trans fluid has been changed. Things I know to be bad: Rusty on doors and some on wheel wells. Needs complete brake job. No Cat. Hard to get into 4-lo.
This vehicle can be driven but would need work for inspection or would make a great parts vehicle.
Ask me any questions and I will answer honestly. I loved this vehicle when I drove it regularly and I would just like to see someone get it who really needs it. I've owned it for the last 11 years and before I had it, it was owned by a parts store owner who ran Amsoil in it from new. Unfortunately it has just been permanently replaced by a diesel Excursion. I'd like to get $800.00 for it.